Land Surveyor Forum

Replies

• GEO Ambassador

  Jaybird May 24, 2012 at 3:01pm

  Have you tried the "Station Offset to Points" report? That works on an alignment and a set of points.

  
  

  You could also create points via the MEASURE ALIGNMENT option and set them up to pull the point descriptions from the alignment stations:http://docs.autodesk.com/CIV3D/2012/ENU/filesCUG/GUID-9ED65C63-58AE...

   

  

  You can find it in the TOOLBOX tab of Toolspace:

  

  As another note, the Sincpac-C3D STAOFF command is in the unlicensed (free) version.  This command is essentially the same thing as the old "Display Points by Sta/Off" command from LDD.  There are some other, neater and more-powerful commands in the purchased version of the Sincpac-C3D, but you can use the STAOFF command with no activation key (just download and install the software).

   

  The primary benefit to this command vs. C3D's built-in report is the ease of point selection.  For example, you can select a few points graphically on-screen and immediately see their Sta/Off in a list in the command window, with very few mouse clicks.

  
  

  

  Creating Points on an Alignment Using a Distance Interval

  Creates points at equally spaced intervals along an alignment.
  • 

    John Quinn > Jaybird May 24, 2012 at 5:26pm

    Hi Justin,

    The problem I'm having is that I want to only do 80 points out of 5000 points. I have those 80 isolated to a point group but don't see any method of either isolating just point group or range of point numbers.  Still missing LDD.