Hello,
I have been trying to connect a TSC2 controller to my R8 Model 3 receiver with no luck.
Here are the steps I follow:
1. Level tripod and turn receiver on
2. Turn on TSC2, start a new job
3. Go to Configuration, Controller, Bluetooth, Config
4. Under Mode, I check "Turn on Bluetooth" and "Make this device discoverable to other devices"
5. Under Devices, select "New Partneship" and the controller scans for Bluetooth devices.
6. After a few moments, the TSC2 does pick up the signal from the receiver.
7. Back under Devices, I select the correct device ans select ok.
8. This brings me back to the Bluetooth screen where the correct receiver is listed...
Here I leave "Connect to Laser: None" and "Send ASCII Data to: None"
Then I select accept...
On the right side of the screen, after a few moments, I should see that the two devices are reading each other. After 20 seconds or so the TSC2 says the receiver is not recognized...
This is the point where I'm stuck.... Thoughts/ideas?
Thanks,
Nick
Replies
Hey Nick, this is Skip Farrow, why don't you call me, and solve this issue 843.518.8488 /South Carolina
otherwise, when your in front of your computer.we can discuss in the skychat room. i'll be looking for you
I was out of the office yesterday and will be for much of the day today. I may return after lunch. I will get the gear up and running thne give you a call. Thanks for the reply.
Hey Skip, did Nick call you yet?