Land Surveyor Forum

Replies

• 

  Billy Brooks March 25, 2016 at 8:42am

  Hello Aminu, Can you call where you got it . The Dealer has a direct line to a repair tech at Leica.

  You did not change the settings on anything, Are you just using GPS with no Robotics. this error will happen when you are using them together. Call this Number for support do you have codes for support. can you get to a fax.  also does it have differential mode this error also will shows up in it

     SUPPORT CONTACT

  PH. +4 171-727-3131

  Fax  +4 171-727-4674
  • 

    Billy Brooks > Billy Brooks March 26, 2016 at 3:38am

    Hello Aminu, I read your manual there was no trouble shooting in it  i knew this before i read it. the manuals today do not go over them like before. I looked in my Leica tech manual some errors like this could be caused like i told you when robotics are involved  lost of lock. i did not see anything with this unit and robotics, also the differential gps can have similar error are you doing this. i did read it was capable of this. also your bluetooth  five things,,   the applet scan want find device because two device in area . blue tooth out of range, bluetooth finds null device., intermittent  signal. scan can not find receiver then do a warm boot on the receiver. also to switch receiver on and off fast then another scan.then it gives no coordinates on this point as in none in review,or grid coordinates in review must be set to grid, No data recorded in receiver, receiver batteries are weak, then it gets to the radio as the source  check all radio cables, connected into correct ports, make sure the radio is configured correct, and good power, then it says check all radios and repeaters, make sure you do not need a repeater because you are out of range. this covers more than your unit.  it did not list the error exactly like you said, it did not list it at all in the error list like you said this is some of the reasons for a invalid. points i had no code to match this ,my number 2 was something different not this. this manual is 950 pages i will look again to see if i miss something but it maybe something i already listed

     sorry about your luck. and it could be something is broke or damage. and none of this will help.

    billy
• 

  David García Bodego March 25, 2016 at 12:01am

  You should be more specific:

  What are you doing?

  When is it shows?

  Which data have you introduce?
• Party Chief

  Jaybird March 11, 2016 at 8:12pm

  the attached manuals for the SR20 by Leica may help..  let me know if it doesn't and ill see if i can dig up something more specific.. good luck buddy!
  • 

    Aminu Abdul > Jaybird March 12, 2016 at 6:04am

    Thanks Justin Farrow, I do have same manuals but could not figure-out solution out of it. I will be glad to have another option if possible.