Land Surveyor Forum

Replies

• 

  Timothy Beach March 25, 2010 at 5:46pm

  Make sure that you make the point ID the station ID, that way, it will average the coordinates, no mater how many times you take the point. If you make the station ID the feature code, it will record the point multiple times with different point numbers, which is why you could end up with a large number or points called for example, STN1.
  
  Hopefully that makes some sense!
  
  Tim
• Party Chief

  Jaybird March 15, 2010 at 12:21pm

  We have a new support group for Leica products....check it out here
• 

  Evgeny January 31, 2010 at 5:34pm

  If you setting up on know point and back-sighting known point you will need to have your known points in DATA of your JOB. From my limited knowledge of Leica 1200 field software, it operates with something called triplets, which is kind of way to store different kind information. So, for example if you measures the BS it will store it as a triplet. If you measure your BS from different setup point, it will store different triplet under the same point number.
  
  I don't know how well it answers the question...let us know Siva.
  • 

    Siva kumar > Evgeny January 31, 2010 at 9:55pm

    Thank you very much Evgeny for your response.
    Still I want to know whether there is any settings to separate or hide these triplets from other datas.
    Once again thanking you.
    • 

      Evgeny > Siva kumar January 31, 2010 at 11:35pm

      There might be, I think they would be called filters in the TPS, but be careful with it...I personally like triplets, because I put my data through LGO and then through STAR*NET, but only for complicated cases that need comprehensive L.S. adjustment.
      
      Take look at filters anyway...