Land Surveyor Forum

Replies

• 

  Virginia Beck July 31, 2017 at 6:48pm

  check receiver set up make sure that it is enabled from factory.
  • Land Surveyor

    Collins Iheanyi > Virginia Beck August 2, 2017 at 3:21am

    thanks...i had to update the firmware version and it has started working normally
• Land Surveyor

  Sergio Manuel León Galán July 29, 2017 at 4:33pm

  Sorry my English is not good. I had similar problems with other receivers and it was almost always battery problem. The lack of energy can cause the job configuration files to be saved or corrupted. In many occasions the solution was painful, to reinstall the software of the pda. Is but that it is not your case, also can be a problem of configuration of the work, some loose parameter. I do not know that equipment, but some gps receivers do not check data if there is a fault in the job configuration, such as the reference system. Check if the gps receiver has a record of pure observations to satellites; In your technical service you can recover the points from the record of observations, although you may have to do a transfer of reference system
• Student Surveyor

  Alex Burmicz-Woznicki July 29, 2017 at 3:39pm

  Can you view any data in a text format? I think there was a problem similar to this that I had where the data was collected but the instrument took an average of the data collected and just gave one figure of x, y, z which was unusable. I think it's something to do with the profile settings. This was on a GS 500 I believe though so might be different.
• Land Surveyor

  William Kenter July 29, 2017 at 3:28pm

  Are you using a card to store the data on?
  • Land Surveyor

    Collins Iheanyi > William Kenter July 31, 2017 at 3:11am

    No...the data is stored in the Rover