🌐 Show Forums for All Locations
Show the latest social shares
USA Surveying Forums
United States Surveyors
- Arizona
- Alabama
- Alaska
- Arkansas
- California
- Connecticut
- Delaware
- Florida
- Georgia
- Hawaii
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New York
- North Carolina
- North Dakota
- New Mexico
- Oklahoma
- Ohio
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Texas
- Utah
- Vermont
- Virginia
- Washington
- Wyoming
- Wisconsin
- West Virginia
- USA Surveying Events
Asia Surveying Forums
Africa Surveying Forums
Middle East Surveying Forums
European Surveying Forums
South American Surveying Forums
Oceania Surveying Forums
Oceania Land Surveyors
Surveying Equipment Support Forums
Choose Your Equipment Type
Search Survey Photos
Search Surveying Photos by Tag
Add Posts, Surveying Photos, Videos and Articles to the Surveyor Community
Add Stuff to Community
Replies
Dear Sir,
You need to replace the bubble unit. It would cost you around 5$ for it. I have plenty in stock if you need them. My mail id is [email protected]
Regards,
Pranam.
Hi Dave I agree with you, the seal is broken or somewhere it is cracked or broken it may later form one large bubble or not but it is unusable at this point. Most rods this can be replaced.
If not you can use a hand held bubble. It's always a good practice to have a hand held bubble with you it can serve as a good check on any other built in rod bubbles. Most surveyor use one on their level rods that are not made with one. Now checking if a rod bubble is plumb, that's another story but a very important one.
You dropped it and from the look of that pole you definitely don't take care of your equipment
many other answers over here as well