Replies to This Discussion

Seeking EmploymentPermalink Reply by Dean Ryan Davis on May 27, 2018 at 3:28pm

Use the mark that coincides with the vertical axis of the scope.

• ▶ Reply

Permalink Reply by Hunter J. Edwards on May 27, 2018 at 4:39pm

Leica usually has a dot/hole that you measure to on only one side.

• ▶ Reply

Permalink Reply by Kevin Singer on May 27, 2018 at 4:41pm

Use the mark that coincides with the HORIZONTAL axis of the telescope.

• ▶ Reply

Seeking EmploymentPermalink Reply by JOHN DANIEL YORK on May 27, 2018 at 9:30pm

I agree with Hunter above. I just Googled the leica ts11 & viewed the instrument. On the same side as the battery, there is a singular "dot" above the battery, on the same level as the middle eyepiece. ENJOY.

• ▶ Reply

Permalink Reply by Mohammad Salem on May 28, 2018 at 5:25am

Yeah, but every of them give the deference height, I think one of them should be the correct one.  

• ▶ Reply

Permalink Reply by NAYUM KHAN on May 28, 2018 at 12:11am

U have to measure center of the eyepiece frm any suitable side......

• ▶ Reply

Permalink Reply by Carlo Alberto Birocco on May 28, 2018 at 4:48pm

Mohammad,

the two dots are at the same height when the instrument is good levelled.

Otherwise, the rotation axis of the telescope can't be horizontal and both horizontal and vertical angle will be wrong.

The slightly (I hope ...) differences You found are related to the difficult of measuring the vertical height with a meter tape.

The better way is using the GHT196 holder with GHM007 tape meter. Is expensive, but very precise.

Bye 

Carlo Alberto

• ▶ Reply