Land Surveyor Community Forum

Hi

i work with magnet field software on sokkia GCX2. Yesterday i made a mistake and i enter distance for offset from start point and not from end point of line. I tried find coordinates of start and end point of line in raw data but i was unsuccessful. Where i find them? Start point and end point of line were measured only in offset tool.

Thanks very much for your time and help.

You need to be a member of Land Surveyors United - Surveying Community & Forums to add thoughts!

Join Land Surveyors United - Surveying Community & Forums

Email me when people reply –

Replies

  • Party Chief

    Attached is a manual for the Sokkia GCX2 if that helps..

  • These coordinates could be found in magnet tools. If you can't figure it out I might be able to do it for you.
This reply was deleted.

Answer As your Facebook Page

More from Land Surveyor Forum