Just purchased a sokkia set 3b II.  Wondering if anyone knows the volts / amps / watts paramaters for the power port (3 pin) on bottom side of instrument (label says 6V)?

This Content Originally Published by a land surveyor to Land Surveyors United Network

Views: 52

See Your Saved Posts Timeline

Replies to This Discussion

Not sure specifically about that unit but I have attached the manual...perhaps that will help

Download Survey Documents-Members Only
Was this resource helpful? Show your appreciation with a comment below. 

Donations are how we exist and grow for the surveying community worldwide.

I have the manual and I have found a document explaining in 11 or so pages the communications protocol.  I have tried a cell phone app from systranova that allows me to read the azimuth, horrizontal distance and slope distance however the feature in this app that allows the user to set the horrizontal azimuth does not work. I wish the land surveyors united page was all text so that when using the site everything would stay still long enough to look for things.  Where can I get the origional software to connect the set3bii to a PC.  My instrument SN is 3595x ver of the internal CE software is 70-02.

Also it would be nice to have a clean version of the manual not this blurry xerox version.  I have contacted Sokkia and they are less than helpfull.

Well I think I have figured out some of this.  I finaly got a little DC-DC converter module off ebay.

Ebay item # 263047190603 $4.65 including postage.  It allowed me to take a 12 volt battery and step it down in voltage.  I set it at 6 volts and hooked it up to the pigtail I made.  It pulled about .6 amps then dropped down to about .34 amps but the display on the total station said the battery was low and started the fast beep.  I then cranked it up to 7 volts but when I turned it back on it only showed me about 2 out of 3.  I turned it up to 7.25 volts and when I turned it on it said 3 out of 3 (at or near full charge).  When I set vert and horrizontal and then measured distance to a target it went thru the measurement with the amperage going up to about .63 then dropping to .34 amps.  Measurement was exactly same as with factory battery charged to 7.45 volts.  By carefully playing around I have a working power supply.

I found the power connector at

Western States Cabling Inc,    656 Confluence Ave.    Murray, Utah  84123      [wsc_logo3]    [email protected]<mailto:[email protected]>

RSS

Where Thousands of Professional Land Surveyors, Students of Surveying and Educators are United through Collaborative Knowledge and Purpose.

Tools,Apps and Quick Guides

Surveyor Community Hubs For World Regions

Surveying Hubs For US States

Social Support For Equipment

Surveying Photos by Tag

Surveying Videos by Tag

BMC logoSupport Us! +LandSurveyorsUnitedon Google+

Next Generation Land Surveyor Community Where Every Day is a Surveying Conference

Surveyor Birthdays

Surveyor Birthdays Today

Surveyor Birthdays Tomorrow

© 2018   © Created by Land Surveyors United   Powered by

Badges  |  Contact LSU  |  Privacy Policy  |  Terms of Service