🌐 Show Forums for All Locations
Show the latest social shares
USA Surveying Forums
United States Surveyors
- Arizona
- Alabama
- Alaska
- Arkansas
- California
- Connecticut
- Delaware
- Florida
- Georgia
- Hawaii
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New York
- North Carolina
- North Dakota
- New Mexico
- Oklahoma
- Ohio
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Texas
- Utah
- Vermont
- Virginia
- Washington
- Wyoming
- Wisconsin
- West Virginia
- USA Surveying Events
Asia Surveying Forums
Africa Surveying Forums
Middle East Surveying Forums
European Surveying Forums
South American Surveying Forums
Oceania Surveying Forums
Oceania Land Surveyors
Surveying Equipment Support Forums
Choose Your Equipment Type
Search Survey Photos
Search Surveying Photos by Tag
Add Posts, Surveying Photos, Videos and Articles to the Surveyor Community
Add Stuff to Community
Replies
The referenced Back sight point is not in either the Work file or the Control File.
Also I would use Leica LGO 8.4 to process the survey data. You lose a lot of the capabilities of the instrument when you export to a *.RW5 file. LGO will process all of the Smart Station Setup routines.
Known Back Sight, Known Azimuth, Multi-point Resections, GPS Smart Station.
Jim
Leica System TCRP1200 Smart Station, GPS 1200GG
here are the
Leica Smartworx manuals and guides if you need them...tech manual
getting started guide
I am using a cs15 leica data collector. i stored the point but it randomly does not show up in the raw file.