🌐 Show Forums for All Locations
Show the latest social shares
USA Surveying Forums
United States Surveyors
- Arizona
- Alabama
- Alaska
- Arkansas
- California
- Connecticut
- Delaware
- Florida
- Georgia
- Hawaii
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New York
- North Carolina
- North Dakota
- New Mexico
- Oklahoma
- Ohio
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Texas
- Utah
- Vermont
- Virginia
- Washington
- Wyoming
- Wisconsin
- West Virginia
- USA Surveying Events
Asia Surveying Forums
Africa Surveying Forums
Middle East Surveying Forums
European Surveying Forums
South American Surveying Forums
Oceania Surveying Forums
Oceania Land Surveyors
Surveying Equipment Support Forums
Choose Your Equipment Type
Search Survey Photos
Search Surveying Photos by Tag
Add Posts, Surveying Photos, Videos and Articles to the Surveyor Community
Add Stuff to Community
Replies
Nobody knows Pentax better than Surveyors in the UK!
This is the answer I was going to suggest, but I also think in the setting in the "units" you can define the # integer's and your display. Good Luck. I ran a pentax total staion with TDS and Trimble data collectors it was great set up.
Thank everyone, i'm very much grateful
Reduce your values by #000000.0000?
I'll see if I can help you drum up the answers you seek... but just FYI asking in the Pentax Support Group forum may bring you more luck because the members of that group are Pentax Users